Cartographer3D

Bed Mesh Generator

Generate correct Klipper [bed_mesh] settings for BED_MESH_CALIBRATE, accounting for your probe offset.

Bed Size

This is the size of your bed, if you have a 235x235mm bed, put 235 in X and 235 in Y.

Bed Size X (mm): Bed Size Y (mm):

Mesh Points and speed

This is how detailed you want your bedmesh to be, the total number of points would be calculated by multiplying X by Y. Probing speed is the speed you want to mesh at, this will obviously be limited by your printers capabilties.

Mesh Points X: Mesh Points Y: Probing Speed (mm/s): Edge Margin (mm):

How far the mesh stays back from the edge of the usable area. 10mm is a safe default.

Probe Location

Take the X and Y offset of your probe from your [scanner] section of your config, if you do not know this information, please use this tool designed by Esoterical

Probe Offset X (mm): Probe Offset Y (mm):